Kitchenaid KKECT025 Instrukcja Użytkownika Pobierz pdf (Strona 25)

25

Caring for Your Gas Sealed Burner Cooktop

Caring for your cooktop

Your cooktop is designed for easy care.

You can do most cleaning with items found

around the home. Cleaning your cooktop

whenever spills or soiling occurs will help to

keep it looking and operating like new.

NOTES:

• Before cleaning make sure all controls

are off and the cooktop is cool.

• Do not obstruct the flow of combustion

and ventilation air.

• If knobs are removed while cleaning, be

careful not to spill liquids through holes in

the control area.

• Be careful not to allow moisture to collect

in control area. Moisture could cause igni-

tor switches to fail.

Surface burners

• The burner caps should be routinely re-

moved and cleaned. Always clean burner

caps after a spillover. Keeping the burner

caps clean prevents improper ignition and

an uneven flame.

• For proper flow of gas and ignition of the

burner, DO NOT ALLOW SPILLS, FOOD,

CLEANING AGENTS, OR ANY OTHER

MATERIAL TO ENTER THE GAS TUBE

OPENING.

• Occasionally check the burner flames for

proper size and shape as shown later in

this section. A good flame is blue in color.

If flames lift off ports, are yellow, or are

noisy when turned off, you may need to

clean the burners.

NOTE: To check oven burner flames for

proper size and shape, see the Installation

Instructions also included with the range.

To clean burners and burner caps:

1. Lift the burner cap straight up from the

burner base.

2. Clean burner cap with warm, soapy

water and a sponge. For stubborn stains,

clean with a mildly abrasive plastic scrub-

bing pad and powdered cleanser. Do not

clean burner cap in dishwasher.

3. If the gas tube opening or the orifice,

located inside the opening, has become

soiled or clogged, use a cotton swab or

a soft cloth to clean the area.

4. If ports are clogged, clean with a

straight pin. Do not enlarge or distort

port. Do not leave anything stuck in

the ports.

5. After cleaning the gas tube opening and

ports, replace the burner cap. To re-

place burner cap, make sure cap is

properly aligned and leveled.

6. Check the burner after cleaning for

proper lighting.

Gas tube

opening

(orifice)

Ignitor

Burner cap

4454944v11c46 8/25/98 2:58 PM Page 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Komentarze do niniejszej Instrukcji

Brak uwag