KitchenAid KHMP5 86510 Instrukcja Obsługi

Instructions for useGBIT

10The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage a

11Note: Refer to the table on page 6 to ensure the correct typeof injector is to be fitted.Traditional burners (T)1. Remove the cap (A).2. Remove the

12To replace the injectors in special burner it is necessary to:1. Remove spreader (C), the screws (B) holding the cover cap (A)and the cap itself.2.

13Before any cleaning and/or maintenanceoperation, disconnect the hob from powersupply and wait until it is cold.To keep the hob in perfect condition,

14If the hob is not working properly work throughthe this guide before contacting our CustomerCare Centre.The burner does not ignite, or the flame isu

400010766428Printed in Italyn03/15Whirlpool Europe S.r.l.Viale G. Borghi, 27 - 21025 Comerio (VA)Phone 0332.759111 - Fax 0332.759268www.whirlpool.eu

Product description and symbols 4Using the burners 4Practical advice on using the hob 5Positioning the pan supports and wok support 5Hood and cabinetr

4To turn on one of the burners:1. Turn the corresponding control knobanticlockwise until the indicator coincides withthe maximum flame symbol .2. Pres

5Read the instructions to get the best out of yourhob.- Use pans with a similar diameter to the burner(see the table on this page)- Use flat bottomed

6If a hood is to be installed above the hob, refer to the hood installation instructions to ensure the correctheight above the hobHood and cabinetry c

7To get the most out of your hob, please readthe instructions carefully and keep them forfuture consultation.• These instructions are only valid in t

8PackingThe packing material is 100% recyclable and islabelled with the recycling symbol . Pleasedispose of all packing responsibly and carefully.Pro

9Technical information for the installer• This appliance can be built into a 20mm to40mm thick worktop.• If no oven is to be installed below the hob